The sand mill is widely used. What problems should we pay attention to during the use? Xiaobian summed up the following points for everyone to discuss.
First, check the sander pot once a day, and then make a record for the pot.
Second, the oil in the box in the sand mill is replaced every six months, and the tank should be cleaned regularly. The filter is cleaned once a month;
3. When we clean the equipment, add some lubricating oil to the lubrication part of the equipment to avoid rusting of the main shaft and the cylinder;
4. When the equipment materials are used for processing, the equipment should be cleaned, so that it is convenient for the next processing of materials and the equipment will not be blocked;
5. Regularly check the easily damaged parts in the grinding machine, such as oil seals, bearings, etc. If it is found that there is wear and tear, it should be replaced and repaired immediately;
6. The use of the sand mill equipment is to be overhauled once a year, and the contactor at the exchange station is overhauled once every six months and replaced properly;
7. If the thermal relay continues to stop due to overload, we should press the “Reset” button in the thermal relay to facilitate subsequent operation;
8. When the sand mill equipment is not needed for a long time, the switch of the equipment should be turned off and the power supply should be cut off, so that the equipment is good and the electricity is saved;